GOST 29296-92

• gost-29296-92.pdf (1.12 MiB)
  ГОСТ 29296-92

GOST 29296−92 Profiles pressed rectangular unequal-section T-section from aluminum and magnesium alloys. The assortment (with Change No. 1)

GOST 29296−92

Group B52

INTERSTATE STANDARD

PROFILES PRESSED RECTANGULAR NON-BINDING
TAVERNAL SECTION FROM ALUMINUM AND MAGNESIUM ALLOYS

Assortment

Extruded rectangular unequishelf T-section shapes
of aluminum and magnesium alloys. Dimensions

MKC 77.150.20
OKP 18 1143

Date of introduction 1993−01−01

INFORMATION DATA

1. DEVELOPED AND APPLIED by the Ministry of Aviation Industry of the USSR

2. APPROVED AND ENTRY INTO ACTION By the Resolution of the Committee for Standardization and Metrology of the USSR No. 108 of February 5, 1992

3. INTRODUCED FOR THE FIRST TIME

4. REFERENCE NORMATIVE AND TECHNICAL DOCUMENTS

5. REVISION. May 2004

APPENDIX Change No. 1, adopted by the Interstate Council for Standardization, Metrology and Certification (Minutes No. 29 of 24.06.2006). State-developer Russia. By order of the Federal Agency for Technical Regulation and Metrology of 29.11.2006 N 280-st was introduced into the territory of the Russian Federation from 01.07.2008

Change No. 1 was made by the manufacturer of the database on the text of IMS No. 2, 2007


This standard specifies a range of pressed rectangular profiles of an unequal-section T-section made of aluminum, aluminum and magnesium alloys manufactured by hot pressing.

The requirements of this standard are mandatory.

1. The profile numbers and their sizes should correspond to those shown in the drawing and in Table 1.

Table 1