08X18T1 steel
08Cr18T1 steel
Steel 08Cr18T1: a classifier of steels and alloys. Below is systematized information about the purpose, chemical composition, types of supply, substitutes, critical point temperatures, physical, mechanical, technological and foundry properties for the brand - Steel 08Cr18T1.
General information about 08Cr18T1 steel
| The substitute for the following steel grades |
| To substitute for steel grade: 12Х17, 08Х17Т. |
| Delivery type |
| GOST 5582−75 thin sheet. |
| Application |
| Welded structures not exposed to impact loads and working mainly in oxidizing environments, such as nitric acid solutions. application in welded structures is mainly limited to small cross-sections of cases (up to 3.0 mm). It is not recommended for use in welded structures operating under shock loads. Limit temperature of welded structures is not lower than -20°C. Steel is heat and corrosion resistant of ferritic class. |
Chemical composition of 08Cr18Ti1 steel
| Chemical element | % |
| Silicon (Si), not more | 0.8 |
| Manganese (Mn), not more than | 0.7 |
| Copper (Cu), not more than | 0.30 |
| Nickel (Ni), not more than | 0.6 |
| Sulfur (S), not more than | 0.025 |
| Titanium (Ti) | 0.6−1.0 |
| Carbon ©, not more than | 0.08 |
| Phosphorus (P), not more than | 0.035 |
| Chrome (Cr) | 17.0−19.0 |
Mechanical properties of 08Cr18Ti1 steel
Mechanical properties of sheets
| Heat treatment, delivery condition | Section, mm | σB, MPa | δ5, % |
| Annealed 830−860°C, air or normalized 960−1000°C, air or water (cross-sectional samples) | <3,9 | 460 | 30 |
Mechanical properties depending on degree of cold working
| Heat treatment, delivery condition | σB, MPa | δ5, % | ||||||||||||
| Sheet of cross-section 3 mm. Hardened at 850−870°C, water. | ||||||||||||||
| Degree of deformation - 0% | 540 | 36 | ||||||||||||
| Level of deformation - 13% | 710 | 9 | ||||||||||||
| Degree of deformation - 29% | 790 | 3 | ||||||||||||
| Degree of deformation - 46% | 870 | 2 | ||||||||||||
| Degree of deformation - 55% | 890 | 2 | ||||||||||||
| Degree of deformation - 60% | 920 | 2 | ||||||||||||
| Degree of deformation - 66% | 980 | 2 | ||||||||||||
Technological properties of 08Cr18Ti1 steel
| Forging temperature |
| The beginning 950−1050, the end 720−800. Cooling is done in the air. |
| Weldability |
| limited. Satisfactory mechanical properties can be obtained when welding products with small thicknesses up to 2−3 mm. Sv-08H20N9G7T and Sv-05H25N12TU wires are used for automatic submerged-arc welding under flux AN-26 and ANF-14. Steel is successfully welded by argon-arc welding without filler material and with 10X18H10T steel wire as a filler material. Contact welding is used for small sections. |
