Alloy AO6-1
Alloy AMK
Alloy AMST
Alloy AH-2.5
Alloy AO12-1
Alloy AO20-1
Alloy AO3-7
Alloy AO6-1
Alloy AO9-1
Alloy AO9-2
Alloy ACM
Designation
| Name | The value |
|---|---|
| Designation GOST Cyrillic | АО6-1 |
| Designation GOST Latin | AO6-1 |
| Transliteration | AO6-1 |
| The chemical elements | - |
Description
Alloy AO6−1 is applied: to obtain a bimetal strip with steel and aluminum by rolling and subsequent punching of liners with a thickness of friction layer is less than 1 mm.
Note
The recommended modes of operation:
— load ≤ 31,2 Mn/m2 (320 kgf/cm2);
— sliding speed ≤ 20 m/s;
temperature ≤ 120 °C;
— recommended shaft hardness ≥ 250 HB.
On an antifriction layer of articles coated with a soft metal or a polymer antifriction coating thickness of from 0.003 to 0.03 mm. permitted by agreement with the consumer in technically justified cases to cover the product with a soft metal or polymer coating.
Standards
| Name | Code | Standards |
|---|---|---|
| Non-ferrous metals, including rare metals, and their alloys | В51 | GOST 14113-78 |
Chemical composition
| Standard | Si | Ni | Fe | Cu | Al | Sn |
|---|---|---|---|---|---|---|
| GOST 14113-78 | ≤0.3 | 0.7-1.3 | ≤0.3 | 0.7-1.3 | The rest | 5-7 |
Al is the base.
According to GOST 14113-78, the content of other impurities is not regulated individually, and the total content of other impurities should be ≤ 0.30%.
According to GOST 14113-78, the content of other impurities is not regulated individually, and the total content of other impurities should be ≤ 0.30%.
Mechanical characteristics
| Section, mm | sT|s0,2, MPa | σB, MPa | d5, % | Brinell hardness number, MPa |
|---|---|---|---|---|
| Casting in a metal mold in the state of delivery | ||||
| ≥80 | ≥160 | ≥12 | ≥45 | |
Description mechanical marks
| Name | Description |
|---|---|
| Section | Section |
| sT|s0,2 | Yield strength or limit of proportionality with a tolerance for residual deformation of 0.2% |
| σB | Limit short-term strength |
| d5 | Elongation after rupture |
